Operations of commercial wet grinding pulveriser : -
The flow of material from the Feeding Hopper is regulating by means of side handle easily to suit the load. Rotor runs in anti-clockwise direction. The beaters pass just beneath the Ratchet Teeth Liner fitted inside the top half of the crushing chamber, leaving a gap of 1/8" between the liner teeth and the tips of the rotating beaters. This cuts the material caught between the liner teeth like a sword with a scissors action at a 2880 R.P.M. After the required size reduction, the material will pass through the screen fitted inside the lower discharge end of the grinding chamber. No sieving is required, as the appropriate size screen fitted will not allow coarser material to pass through. The air generated in the crushing chamber forces the powder to pass through the screen fitted at the bottom discharge end of the crushing chamber, into a Filter attached to the delivery trough below. (When crushing Wet-Pulpy materials, the balloon should not be use)
Servicing Guidelines of commercial wet grinding pulveriser
Open the cover of chamber all grinding parts cleaned with a brush in couple of minute and the Pulverizer is ready for next crushing. If required, the grinding chamber can also be wash with water. Remove the cotton balloon and the screen, close the cover tightly and start the grinder. Now pour a bucket or two of water into the hopper. The grinding parts will be flushed with the water and cleaned. Continue running the machine for a few more minutes as the draft of the fresh air sucked into the grinder will dry it. The beater when worm out removed and reserved by removing the cur clip lock holding to the rotor pins. When both the edges are worm out, they sharpened on an emery stone, to be use as new. In addition, when completely warn out, replaced the equal weight and refitted.
Application of commercial wet grinding pulveriser
commercial wet grinding pulveriser are exclusively meant for the grinding of Green chilli, Onion, Tomato, Dry ginger, rice, black grams, cashew nut, dal, coconut, mango, pineapple, garlic, on a large scale basis.
| Model No |
Jas 1202 |
Jas 1203 |
| Chamber Size |
08 “ X 04” |
08” X 08" |
| Motor H.P.( KW) |
1.5 ( 1.125 KW) |
2 (1.5 KW) |
| RPM |
2880 |
2880 |
| Size of machine Approximate |
48 X 33 X 63 CM 36 Kg. |
55 X 40 X 90 CM 59 Kg. |
Note Wet Grinding Pulveriser is also available in 3 H.P. & 5 H.P. three phase Model.
Options ofwet grinding pulveriser
* 110 Volts Single Phase motor insted of 215 Volts Single Phase Motor
* 220 Volts Single Phase motor insted of 440 Volts Single Phase Motor
* All contacting parts Stainless Steel 304 / 316
